For Yamaha Immobiliser Emulator 2002 - 2021 R1 R6 MT07 MT09 MT10 TMAX XMAX Compatible 2002 - 2021 For Yamaha models: YZF R1 / YZF R6 FZ6N / FZ6S XJ6 T-MAX X-MAX V-MAX MT03, MT07, MT09, MT10 MAJESTY 400 XSR700 XSR900 This new version has been redesigned with the following features: Custom Firmware - Allows compatibility with a wide range of models Reduced Power Consumption - Lower current draw from battery in standby mode Higher Rated Capacitors - Improved reliability and durability Dual Layered PCB - Enhanced resistance to corrosion in damp or wet conditions Compact Design - Minimal wiring and clean installation 30% Smaller PCB - Reduced size and weight compared to previous versions Water Resistant Casing - Sealed unit prevents water ingress This item is designed for the following purposes: Engine swaps where the existing immobiliser unit is not compatible with the new engine ECU Removal of damaged immobiliser units due to theft or recovery damage Avoiding high replacement costs associated with dealer-programmed immobiliser and ECU units Use in project bikes with Yamaha engines and ECUs that do not include an immobiliser system Diagnostic use by eliminating the immobiliser as a potential cause of starting issues This 6-wire version offers high compatibility by utilizing the full manufacturer wiring schematic, which may maintain immobiliser dashboard LED functionality depending on the model. Firmware is programmed to ensure broad compatibility across listed Yamaha models. If this product does not function with your listed Yamaha model, it may be returned for a full refund. Fitting Instructions: 1) Trace the wiring from the key barrel transponder to the ECU, typically located under the fuel tank or near the headlight. 2) Disconnect the original immobiliser and connect the plug-and-play emulator. 3) The vehicle can now be started without a transponder key.