Adopt high-quality double-panel design, with power indicator and TTL signal output indicator. With DO switch signal (TTL) output and AO analog signal outputTTL output high and low level. (Can be directly connected to the microcontroller or relay module)The analog output voltage changes with the concentration. Fast response recovery feature. Has long service life and reliable stability. Electrical performance:Input voltage: DC5V Power consumption (current): 150mADO output: TTL digital quantities 0 and 1 (0. 1 and 5V)AO output: analog level signalSpecial reminder: After the sensor is powered on, it needs to be preheated for about 20S, and the measured data is stable. It is normal for the sensor to heat up, because there is a heating wire inside, if it is hot, it will not be normal. Wiring:1. VCC: connect to the positive pole of the power supply (5V)2. GND: connect to the negative pole of the power supply3. DO: TTL switch signal output4, AO: analog signal outputColour:greenMaterial:MetalPackage Contents:1 x MQ136 Hydrogen Sulfide Sensor ModuleOnly the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm. Note: Please allow slight errors due to manual measurement. Please make sure you don't mind before bidding. Color may vary depending on your monitor, please understand. Note: Hello, please pay attention to your shipping address when purchasing products. If your delivery information (e.g. name, street, house number, doorbell/email without name, etc.) is incorrect, the order will not be delivered correctly