Feature:1. MAIN FUNCTIONS: Tool setting probe is used for tool setting operation on CNC machining center. For tool length measurement and tool damage detection, the program drive the tool to approach the needle in the Z direction2. EASY SETUP: The radius compensation of the rotating tool is set on the X and Y axes of the machine, the screw adjustment tool align the measuring needle with the axes of the machine, and the interface handle the signal between the tool setter and the CNC controller3. HIGH ACCURACY: The tolerance of the tool is determined by the flatness and parallelism of the tip setting. The 5m front to back value and the face to face value can be easily obtained by the plane ratio of the tip, and the 5m parallelism can be easily obtained by the axes of the square tip needle, which is accurate enough to meet the needs of most tool setting applications4. APPLICABLE SCENARIO: Tool setting and tool damage detection can also be performed on various types of vertical and horizontal machining centers and various gantry machining centers by axes tool setter5. EXCELLENT PERFORMANCE: Tool setting probe is made with fine workmanship, possess compact appearance and stable performance, can make sure durability and stabilitySpecification:Item Type: Tool Setting ProbeMain Applications: Tool setting and tool damage detection on various types of vertical and horizontal machining centers and various gantry machining centersTransmission Type: Hard wired transmissionReceiver or Interface: MI8-4, HS1 or HSI-CRecommended Needle: Disk (tungsten carbide, 75 for Rockwell hardness) or square (ceramic tip, 75 for Rockwell hardness)Weight (including disk needle): 1055 g / 37.2 oz(approx.)Cable (to interface):Specification: Diameter: Approx. 4.4mm / 0.17in, 4 core shielded cable, each core is 7x0.2mmLength: Approx. 10meter / 32.8ftElectrical Connection: Wire from the end of the device X, Y, +ZInduction Direction: Wire from the end of the device X, Y, +ZMeasuring Force: 1.30N to 2.40N, 133gt to 245gf (depending on induction direction)Protection Class: IPX8, BSEN60529: 1992: 2013(IEC60529: 1989: 1999: 2013)Installation: 1/2in T bolt (not included) for Spiroll cylindrical pin option for accurate installationStorage Temperature: -10 to +70Operating Temperature: +5 to +60Main Applications: Hard wired workpiece inspection and transmission interface for tool setting probe, for transmitting and processing signals between probe and CNC machine controller.Transmission Mode: Hard wiredProbes For Each System: TwoCompatible Probe: LP 2 and variants, TS 20, TS27R and TS 34Power Supply Voltage: 15Vdc to 30VdcPower Supply Current: Up to 80mA (each XAE/ZA E output connection will increase the power supply current). The power supply is protected by an internal FS 1Output Signal: Probe statusIsolated "totem pole" transistor output that can be configured to normally high or normally low. Can be configured for TTL compatibilityFour optional shaft outputsNon isolated "totem pole" transistor outputs that can be configured to normally high or normally lowOutput Protection: Maximum 10mA at 30V. All outputs are short circuit protected by current limiting circuitsDiagnostic LED: Probe status, axes movement (Z+, Z-, X-, X+)Mounting: DIN rail mounting or double lock padSetting: Storage Temperature: -25 to +70 (-13 to +158)Operating Temperature: +5 to +55 (+41 to +131).Package List:1 x Axes Tool Setting Probe1 x Interface Unit Board3 x Protective Shell Accessories4 x Sticky Films1 x Electronic Component1 x Measuring Needle12 x Accessories2 x User Manuals