Night lamp with baby-safe materials: This Puppy night light children was developed for baby rooms, which is made of high-quality safe materials ABS + PC. The bedside lamp, without a point or sharp edge, with a cute appearance and a special round bottom design is the best doll for your children. Adjustable brightness child night light: The LED night lamp child have two light modes of white light and warm yellow light. Thanks to the high-quality lampshade, the light is so soft that it does not hurt the eyes or disturb the baby while sleeping. Night light children's room with a natural transition can also adjust the brightness continuously. It is the best choice to take care of the children at night as the still light. Night light touch control for children: after pressing your nose, you can switch between three different light modes. The first short press will display the light as warm yellow, the second short press is white, the third short press is natural light. If you press the top with for three seconds, you can adjust the brightness of the light. Rechargeable and Power Saving Night Lights: Thanks to the power-saving design, the puppy lamp can be used continuously for up to 4 hours at maximum brightness, while at minimum brightness it can be used continuously for up to 48 hours. After a single charge, the night light can be used for a few days and is easy to move because of its rechargeable design. In the daytime it is doll and decoration, while in the night it is the guardian of sleep for your children. Product descriptions Color: son Instructions for use: This product is suitable for bedroom, living room,passage, etc. Use a qualified power supply (5 V / 1A) or chargeconnect it to the charging USB port and the computer USB port.Lights up red while charging and full lightgoes out. Tricolor light: 1. Tap the light to turn it on. To thisTime is yellow light. Tap againthe switchable light color (light sequence: yellow light - whiteLight - neutral light). 2. Long press to adjust the brightness of the light.The light has a memory function. Installation method: remove the plaster and thedouble sided tape, stick the double sided tapeon the adsorption iron piece and glue the other sideto the desired location (the gluing position must be cleanwiped to increase adhesion and adhesion). Note: 1. Do not disassemble this product by yourself. Use itnot in a humid or hot environment. 2. This product is not a children's toy and is not intended for childrensuitable for under 6 years. 3. The light source of this lamp cannot be exchangedWhen the light source is ready, please replace the entire oneLights out. 4. If you will not be using this product for a long timerecommended to charge the lamp once every 30 days to use theLife span of the lithium battery after being idle for too longnot to be shortened.