Package include: you receive 5 sets of ceiling fan balancing kit, include 5 pieces plastic balancing clip and 15 pieces self-adhesive 3G metal weight, sufficient quantity is enough to meet your and replacement Specific function: the plastic balancing clip makes it easier to locate problem area and 3 self-adhering 3G weights to help correct the wobble, the permanent weights are secured with a very sticky adhesive which not come free Working principle: according to the physics interpretation, when the fan rotates, the thinner the area of bearing wind is, the less resistance exist for the patch, and it be more favorable for the patch to stick to the fan blade Features: this fan blade balance kit solves the swing problem caused by the irregular blade or blade holder, it not only helps prevent the ceiling fan from wearing, but also helps reduce noise, maintain good support of fan and other components to extend service life Wide compatibility: this fan balancing kit is compatible with most ceiling fans. Using Steps 1. Turn the fan on and set the speed control setting to a speed at which the wobble is the greatest. 2. Turn off the fan and allow it to come to a complete stop select one blade and place the balance clip on it. Halfway between the blade holder and blade tip on the trailing edge of the blade. 3. Turn the fan on Note whether the wobble has increased or decreased. Turn the fan off ,move the clip to another blade, and retest. Repeat this procedure on all noting the blade on which the greatest improvement is achieved. 4. Move the clip back to the blade that showed the greatest improvement. Move the clip inward and outward on this blade and operate the fan to find the position where the clip gives the improvement. 5. Remove the clip and install a balancing weight to the top of blade along the centerline near the point where the clip was positioned. 6. If the fan wobble problem has n