Using XC7Z020-2CLG400I chip xc7z020-2I; The AD9363 chip is configured to use the AD9361 chip, with a frequency range of 70MHz~6GHz and a maximum sampling rate of 61.44MHz. After laboratory testing, no obvious difference from the AD9361 has been found so far; PS 1GB DDR3 32bit bit width, frequency 1066M; 32MB QSPI Flash, supports TF card (TF boot and QSPI boot can automatically switch, inserting the card is TF boot and removing the card is QSPI boot); Onboard JTAG circuit and USB-to-serial port enable power supply and debugging with one cable;<br><br>Description: 1. Support USB OTG, which can be master or slave. All USB interfaces adopt TYPE-C interface. The OTG mode is automatically recognized and the USB port is turned on for power supply; 2. Using VCTCXO, the initial frequency accuracy is 0.5PPM, and supports or 10MHz external taming; 3. Gigabit Ethernet interface; 4. The design current of all power rails in the digital part is 4A, which is sufficient. AD936x uses ADP1755 high-performance to provide power to improve RF performance; 5. Adopt 10-layer PCB wiring, impedance matching, and signal integrity design; 6. The product adopts CNC shell to enhance heat dissipation and strength; 7. It can be used right after booting, the system files are pre-burned in the TF card, and you can follow the introductory tutorial to get started; 8. The software interface is libiio, which can be connected to software that supports libiio, such as iioscope, SDRsharp, Matlab, GNURadio, etc. Material: ABS+aluminum Color as shown<br><br>Package Contents: 1 x Software Radio Development Board 4 x Antenna 1 Set Of Wires Note: Different Batches May Have Differences In Product Appearance, Color, And Printed Characters, Which Not Affect The Use<br><br>Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.