Our splitters meet the highest standards. They are made of materials and are fully shielded, thanks to which they provide the highest quality picture and sound without interference. The device allows you to connect two receivers (eg. TV sets) to one transmitter (e.g. computer or decoder). In this case, the signal is the same on two televisions. They work independently, i.e. both may be active at the same time or only one of them. It is possible that there is also a SWITCH function, where it is possible to connect two HDMI devices (such as a DVD player, DVBT set-top box, game console, Apple TV, computer or Blueray) to one HDMI receiver , e.g. on an HDTV, projector or monitor. Full support for FULL HD and ULTRA HD No drivers required - automatic Plug and Play device HDR and CEC support. TECHNICAL SPECIFICATIONS Input: 19-pin HDMI-A port Outputs: 2x male HDMI-A 19 pin Support for ULTRA HD 4K and FULL HD 1080P and lower resolutions such as: 480p / 576i / 576p / 720p / 1080i / 1080p / 2160P FULL HD 1080P - Supports ULTRA HD 4K - supports 3D Format - Supports sRGB, YCbCr, xvYCC, Depp Color - supports Color depth: 48 bits 8-channel LPCM / 192kHz / 24-bit - Supports DTS-HD Master Audio - Supports Dolby True HD - Supports DVD_Audio - supports Audio Video Sync (AV-sync) - Supports Maximum signal bandwidth: 340 MHz TMDS throughput: up to 10.2 GBIT / s HDCP 1.4, 1.3, 1.2, 1.1, 1.0- compliant For 1080p resolution, it supports cable lengths up to 15 meters for input and 25 meters for output Dimensions: 65 x 62 x 22 mm Scheme of operation: To the splitter, connect the device from which the signal will be sent to the HDMI IN port, e.g. set-top box, console, computer, and then through the splitter connect the receivers to the HDMI OUT ports using HDMI cables, these can be, for example, televisions or monitors. On both receivers there will be the same signal that comes from the transmitter. Scheme of operation: The devices from which the signal will be sent should be connected to the switch to the HDMI IN port, e.g. set-top box, console, computer, and then through the splitter connect the receivers to the HDMI OUT port using HDMI cables, these can be e.g. televisions or monitors.