Features: - Uses the L298N dual H-bridge motor driver IC for strong driving capability, low heat generation, and high noise immunity. - Built-in 78M05 voltage regulator supplies 5V logic power from the motor drive input; when drive voltage exceeds 12V, an external 5V power supply is required. - Includes large-capacity filter capacitors and flyback protection diodes for enhanced stability and reliability. Specifications: - Material: Fiberglass PCB, electronic components - Dimensions: 4.3 x 4.3 x 2.7 cm (1.69 x 1.69 x 1.06 in) - Color: As shown in image - Quantity: 1 pc Technical Parameters: - Module Type: Dual H-bridge motor driver - Operating Mode: H-bridge drive (dual channel) - Main Control Chip: L298N - Logic Voltage: 5V - Drive Voltage Range: 5V–35V - Logic Current: 0–36 mA - Continuous Output Current per Channel: 2A (max) - Storage Temperature Range: –20°C to +135°C - Maximum Power Dissipation: 25W Important Notes: - When drive voltage is between 7V and 12V, the onboard 5V regulator powers the logic circuitry. The +5V pin provides regulated 5V output for external use. Do not apply external voltage to this pin. - When drive voltage is above 12V (up to 24V recommended for reliable operation), remove the onboard 5V output jumper and supply clean 5V externally to the logic input. This ensures proper control signal levels and safe operation of the L298N’s internal logic. - No retail packaging included. - Slight dimensional variation (up to 1 cm) may occur due to manual measurement. - Actual product color may vary slightly depending on monitor settings. Package Includes: 1 x L298N Motor Driver Module