1 Stability: When designing the product, taking into account the stability of the rack, add braces at both ends of the bracket to form a triangular support The sturdy bracket can better avoid the poor contact of the PCI card caused by the distortion of the rack due to the insufficient strength of the rack 2 Strong compatibility: The product supports multiple graphics card installation, and the length and height of the graphics card are not limited by the bracket 3 Heat dissipation: a 12cm fan fixed position is reserved at the rear (a fan is installed depending on the length of the graphics card), and the product has a good heat dissipation effect 4 Fastening: Although this product has only two screws to fix the power supply, the thickness of the material and the reinforced design of the structure are sufficient to fasten the power supply 5 Cold-rolled steel plate material: This product is made of high-quality 0 8mm SPCC steel plate, the surface is baked with black sand grain paint, with fine workmanship, very good quality and long service life Description:The size of the product after installing the power supply: 440x345x160mm;Whether it is possible to install fans: 3 12cm fans can be installed on the other side of the bottom plate (if the graphics card is too long, it will cause interference and cannot be installed); it can also be used to install 120, 240, 360 water cooling radiators;Type: E-ATXProduct Size:E-ATX: 440x345x128mmMaterial:steel platecolour:BlackPackage Contents:1 * Motherboard bracketOnly the above package content, other products are not included Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing The measurement allowed error is +/- 1-3cm