New Reed sensor module magnetron module reed switch MagSwitch compatible with Arduino

New Reed sensor module magnetron module reed switch MagSwitch compatible with Arduino Reed sensor module magnetron module reed switch MagSwitch compatible with Arduino The module features: 1.imported normally open reed 2.the comparator output signals clean, good wavecompatible withm, driving ability, than 15mA. 3.the working voltage of 3.3V-5V 4.the output compatible withm: digital switching output (0 and 1) 5. a fixed bolt hole compatible with easy installation 6.small PCB board size: 3.2cm x 1.4cm 7.using a wide voltage comparator LM393 Instructions Reed is dry reed short, is a kind of passive electronic switch contact element has a simple structure, small size and easy to control, etc., the shell is generally a sealed glass tubes are installed there are two flexible iron reed panels, also called metal rhodium has a filling of inert gas. Normally, two glass tubes made of special materials reeds are separated. When a magnetic substance near the glass tube, under the action of magnetic field lines, the two reed pipe is magnetized and attract each other contacts, the reed will pull together to make a circuit of the connected node communication. After the disappearance of the external magnetic compatible withce, two reeds separately because of their elasticity, the line also disconnected. Therecompatible withe, as a signal to control the use of magnetic field lines switching devices, the reed can be used as a sensor compatible with counting, spacing, and so on (in the security system is mainly used compatible with door sensor, window magnetic production), but also It is widely used in a variety of communication devices. In practice, usually with a permanent magnet control the two metal sheets turned on or not, it is also known as "magnetron." The wiring diagram: Source code: Aduino test program compatible with DO connection (compatible with example) : Aduino test program compatible with DO connection (compatible with example) : Int Led = 13; / / define LED interface Int buttonpin = 3; / / define the Reed sensor interface Int val. / / define digital variable val Void setup () { PinMode (Led, the OUTPUT); / / define the LED compatible with the output interface PinMode (buttonpin, INPUT); / / define Reed sensoras the input interface } Void loop () { Val = digitalRead (buttonpin); / / to assign the value of digital interface 3 read val If (val = = LOW) / / when the Reed sensor have a signal, the LED light { DigitalWrite (Led, HIGH); } The else { DigitalWrite (Led, LOW); } } } If (RI) { The date = SBUF; / / microcontroller to accept SBUF = date; / / microcontroller send RI = 0; } } }