1. CV1 power supply range: 3V-30V, 5V recommended. 2. Bus signal conversion to PWM (supports PPM, SBUS, and CRSF bus signals). 3. Servo reverse (PWM signal inversion). 4. Stroke size (PWM signal reduction or amplification). 5. Delay execution. This controller supports servos, delays, slow speeds, rudder angles, forward and reverse, and an integrated design. Any of these functions can be enabled individually, simultaneously, or simultaneously, without interruption. Servo deceleration execution (slow speed execution, suitable for slow retraction and extension of landing gear or flaps for large UAVs). All of these functions can be configured using the CV1 buttons. You can connect an igniter or smoke generator to achieve sequential ignition. Using CV1s in series: For example, if you set a 2-second delay for each, connect three CV1s in series.This results in signal delays of 2, 4, and 6 seconds. Using CV1s in parallel: For example, if you connect two CV1s with a Y cable,one have a 1-second delay and the other a 3-second delay.Flexible usage scenarios (The product printed words depending on the batch, but this does not affect use) Color: As Shown Material: PCB Package Contents: 1 x Servo Converter Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.