- Built-in Calibration Signal Generator - When not using an analyzer, it can function as a signal generator with two frequency outputs: MF/HF/VHF sine wave output from 0.1 MHz to 350 MHz and UHF square wave output from 240 MHz to 960 MHz. Suitable for automatic self-test and low input calibration. - Input Frequency Range - Two inputs: a high-quality MF/HF/VHF input for 0.1 MHz to 350 MHz and an inferior UHF input for 240 MHz to 960 MHz. - PC Control - Can be connected to a PC via USB and supports the serial over USB protocol (CDC), enabling a wide set of commands. The driver is automatically downloaded after the PC connection. - ESD Protection Function - Version 3.1 with a new ESD protection function and installed diodes, delivering more sensitive response performance, improved antistatic protection, better overall quality, and longer service life. Use scenarios - Use the built-in signal generator for automatic self-test and low input calibration when an external analyzer is not available. - Test and characterize RF circuits and components across the MF/HF/VHF and UHF ranges using the two-input configuration. - Integrate with a PC for automated testing and control, leveraging the CDC USB interface and a broad command set for scripted measurements.