Use STM32F103Vet6 ARM® 32-BIT ®-M3 CPU 3 Road IR2110Strpbf Drive, PWM isolation circuit, anti-upper and lower tube short -circuit logic circuit, and 6 NMOS tubes to form the BLDC driver Default supports 3000rpm brushless motor with a Hall encoder The default supports the maximum load current: 10A, more than 10A will automatically trigger the short circuit protection of the hardware Power supply voltage: DC12-40V 5V and 3.3V isolation power output; Piece 1 reset button and 4 programmable function keys; 1 power supply LED+1 hardware short circuit protection LED+4 programmable LED; Reserve power supply voltage isolation detection circuit and thermal protection circuit; Reserve three opposite electric momentum isolation detection circuits; Reserve three -phase current isolation detection circuit; Reserve SWD program burn port; Reserve a variety of GPIOs such as UART and SPI. Describe: The STM32 FOC brushless motor controller uses STM32F103Vet6 as the main control MCU, the logical chip with PWM signal isolation driver, and the short -circuit of the upper and lower tubes is turned on. The response of the Hall encoder isolation circuit and the hardware overcurrent protection circuit. It can be used to control the Hall with the BLDC brushless motor in 3000rpm 10A. Reserve the bus voltage isolation detection, thermal protection detection, three opposite electric momentum isolation detection, and three -phase current isolation detection circuit to facilitate secondary development. PID closed loop, current voltage isolation collection, carrying 1 reset button and 4 programmable function keys. Colour:Black Material:PCB Package Contents: 1 * Brushless motor drive board Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.