Fitment: For FZ8 (non-ABS) (2010–2015) For Bolt (non-ABS) (2013–2016) For YZF-R1 (2001–2008) For BT1100 Bulldog (2002–2006) For Diversion (non-ABS) (2009–2015) For Drag Star (1999–2006) For FJR1300 (non-ABS) (2001–2005) For FJR1300 (ABS) (2003–2005) For FZ-16 / FZ-S (2008–2015) For FZ400 (1997–2002) For FZ6 (non-ABS) (2004–2012) For FZ6R (2009–2016) For Stryker (2011–2016) For FZ1 (2001–2016) For FZ150 (2015) For FZN150 (2015) For FZ1N (2006) For FZS600 Fazer (1998–2003) For FZS1000 Fazer (2005–2015) For MT-01 (2005–2012) For MT-03 (non-ABS) (2006–2016) For Raider (2006–2016) For Roadliner (2006–2015) For Road Star (1999–2014) For Royal Star (all variants) (1996–2013) For V-Star (950cc and above) (all years) For Warrior (2002–2012) For WR250R / WR250X (2008–2016) For WR450R / WR450X (2008) For XT660 (2004–2015) For XV1600A Wild Star (1999–2005) For XVS950A Midnight Star (2009–2016) For XVS1300A Midnight Star (2007–2015) For YZF-R6 (2001–2016) For YZF-R6S (2006–2009) For Stratoliner (2006–2015) For TDM900 (non-ABS) (2002–2013) For TDM900 (ABS) (2002–2006) For XJ6 (non-ABS) (2009–2015) For XJR400 (2002–2007) For XJR1300 (2004–2016) For XV1900A Midnight Star (2006–2015) For XVS1100 Drag Star (1999–2006) For YS250 Fazer (all years) Condition: Light Source Color: Red / Blue / Green / White / Orange Item Name: Speed Gear Display Indicator Size: 4 cm × 4 cm × 4 cm / 1.57 in × 1.57 in × 1.57 in Features: - Displays current gear number - Indicates gears 1 through 6, plus neutral - Detects gear position faster than indicators relying on speedometer or tachometer signals - Mountable in any convenient location Installation Notes: - Connect the gear display module to power and speed signal lines - Ensure cables are routed safely and avoid interference with steering components Setup Procedure: - After installation and ignition activation, the display counts down from 6 to 1, indicating memory reset - Raise the rear wheel off the ground using a stand; start the engine in Neutral - The display shows “L”, indicating learning mode has started - Select first gear, release the clutch, and maintain speed above idle - The display flashes “1”; continue accelerating in first gear - When “2” appears, shift to second gear and continue accelerating - Repeat for higher gears as needed